SUPERLIFT K796B 4 inch Lift Kit – 2005-2007 Ford F-250 and F-350 Super Duty 4WD – Diesel Engine – with Bilstein Shocks Superlift

SUPERLIFT K796B 4 inch Lift Kit – 2005-2007 Ford F-250 and F-350 Super Duty 4WD – Diesel Engine – with Bilstein Shocks

• Includes frame mounted radius arm lowering brackets.
• Front compression travel-stop relocation brackets prevent suspension over-compression.
• Track bar relocation bracket prevents bind, and the resulting roll and yaw, and steering wheel kick.
• Threaded front anti-sway bar extensions do not require cutting / welding.
• Proper factory steering stabilizer angle is restored for optimum operation.
• Includes either Superide Shocks (gas front, hydraulic rear), or Superide Select Series (SS) monotube gas shock by Bilstein.
• Rear lift via blocks.
• Limited Lifetime Warranty.
• 100% Satisfaction Guarantee

Note: This lift kit is packaged with rear blocks and u-bolts that are configured for the Ford F-250/F-350 pickups with the factory 1 7/8″ blocks without top mount overloads. If your vehicle is equipped with the factory 3.71″ block or top mounted overloads, a longer rear u-bolt will be required and is available from us. Please refer to the option’s list or call our technical support line for additional details.

Shocks: Bilstein Shocks

IMPORTANT DISCLAIMER: The provided tire/wheel fitments are approximate. Actual dimensions of a given tire size can vary considerably from one brand to another. Manufacturers’ wheel offset and backspacing measurement points are not always consistent. Backspacing greatly impacts tire-to-fender clearance when turning. Wheel width and backspacing influence whether the tires protrude past the fenders, and to what extent. Considering these important factors, we recommend that you fit-check your tire/wheel selection prior to purchasing.

Installation Notes:

• Installation time: 8 hours
• Difficulty level: 3 of 5

Additional Info:Factory rear overload springs cannot be retained if replacement rear springs are used.

Dually applications may require different u-bolts.

If vehicle is equipped with top mount overload springs a different rear u-bolt kit is required that is 2″ longer than supplied in lift system; for 2.5″ rear block order part number 11674 or 5″ rear block kit order part number 11694.

If equipped with a two-piece driveshaft, also order carrier bearing drop bracket part number 9649.

If the vehicle is equipped with rear top mount overload springs a longer rear u-bolt kit, part number 11674, is required.